The geometry of the C-12's central mounting holes, combined with the large selection of fasteners that are included with the clamp allow you to securely attach the clamp to a much wider variety of equipment than any other clamp on the market.
It is important that you use the removal and installation instructions on our clamp compatibility section to determine which fasteners are needed for your particular application.
Our clamps have a unique tongue-in-pocket design that protects internal parts from dust and grit.
The tongues are nearly twice as long as those on conventional Arca-Swiss style clamps.
This added length counteracts the tendency of the moving jaw of the clamp to hinge backward during clamping, thus keeping the jaws aligned with the geometry of the plate and eliminating unwanted bending forces on the threaded stud.
There is a stop screw located on the end of the stud.
This screw keeps the knob and internal workings of the clamp captive.
Two shallow channels extend from the sides of the clamp and stop just short of the central tapped hole.
These channels allow greater fore-aft adjustment when using the safety stops on Wimberley quick-release plates.
0.279cm deep slot
3/8" 16 threaded hole (countersunk for flat0head fasteners)